Машина для изготовления угольных стержней

Lubricating oil is often added during use. Lubricating oil is a good helper to assist the coal rod extruder. Continuous heating and friction will cause slowness, which will cause safety hazards for your use. During work, non-staff are not allowed to enter or exit. During use, do not touch the body of the coal rod extruder with your hands to avoid overheating and burns or other safety hazards. During the use of the coal rod extruder, you must constantly check the temperature of the bearings. When the temperature rises and cannot be lowered, you need to stop the machine and check whether the belt is too tight, causing increased friction and causing the temperature of the bearings to heat up. Only Only when the bearing temperature is normal can the safety of use be ensured.

The coal rod extruder uses the screw extrusion principle to compress the prepared cheap pulverized coal into cylindrical or plum-shaped coal rods with a certain strength. It is used to replace expensive lump coal. It can make full use of cheap pulverized coal and reduce fuel consumption. cost. The coal rod extruder uses a variable pitch impeller to forcefully push the coal powder at the rear of the barrel forward. After the coal powder is compressed in the barrel, it is extruded through the round hole in the front head to form coal rods. , there are many shapes of round holes, and there are also many shapes of coal sticks. The coal rod is naturally broken due to gravity during the advancement process.

горячая этикетка : , Скорость экструзии порошка древесного угля, extrusion емкость для древесного порошка, экструзионный блок для порошка древесного угля, Особенность формирования древесного угля для порошка, фабрика формы древесного порошка, инструмент экструзии порошка древесного цвета